Arundel Heating and Cooling Systems Service Policies

Heating and Cooling Plans

Silver Plan

Our Silver Plan offers an annual heating and cooling tune-up for maximum efficiency. If you have a combined heating and cooling plan, both tune-ups will be scheduled on the same day during regular working hours. The plan gives you priority service and written guarantees for your peace of mind. It also includes 20% off repairs. Diagnostic fees and overtime rates are reduced by 50%. You also get $50 per year in Loyalty Credits.

Master heating tune-up and safety check

Furnace
1. Test carbon monoxide levels.
2. Clean and adjust burners and inspect heat exchanger.
3. Check thermostat operation
4. Lubricate all motors, bearings, fans and circulator pumps.
5. Clean pilot assembly.
6. Install standard one-inch filters.
7. Test and adjust operation of safety and operating controls.
8. Inspect flue pipe and gas valve.
9. Check blower motor (and belt if applicable).
10. Test and tighten all wiring and connections.
11. Turn exposed dampers to heating position if marked (no balancing).
12. Inform customer of equipment condition. Recommend necessary repairs.

Hot water boiler
1. Test carbon monoxide levels.
2. Check thermostat operation.
3. Check electrical connections.
4. Lubricate pump bearings and motors.
5. Clean combustion chamber.
6. Check pilot assembly.
7. Check zone valves.
8. Check all safeties
9. Check flue pipe and draft.
10. Check expansion tank.
11. Check aquastat/relay
12. Check water regulator.

Steam boiler
1. Test carbon monoxide levels.
2. Check thermostat operation.
3. Check electrical connections.
4. Clean combustion chamber.
5. Check pilot assembly.
6. Check all safeties.
7. Check flue pipe.
8. Check and drain low-water cutoff.
9. Check gauge glass.
10. Check and adjust water level.
11. Check auto feed (if applicable).

Master cooling tune-up and safety check
1. Lubricate all moving parts, such as blower motor and condenser fan.
2. Check suction line temparature and pressure.
3. Evaluate condition of air filters. Clean or replace with standard one-inch filters.
4. Test temperature drop between return and supply air.
5. Flush condensate drain to protect against overflow.
6. Clean outdoor condenser coil.
7. Check blower motor (and belt if applicable).
8. Adjust blower speed
9. Safety test all controls for proper operation.
10. Meter voltage and amperage in all motoros. Test for worn bearings.
11. Test operation and condition of compressor contacts.
12. Inspect start and run capacitors and relays for bulges, rust and leaks.
13. Tighten and safety test all wires and connections.
14. Clean and adjust thermostat/mercury bulb.
15. Inform customer of equipment condition. Recommend necessary repairs.

Click here to contact our office for pricing